In just seven steps this article will guide you on How to Install a Sub woofer in a Factory Stereo. Very often people who are passionate about adding new additional features to their car stereo like sub woofers take the help of audio professionals to do the job. But this job is not at all complicated and can be done without any experience by following simple steps. In this article we shall also discuss the importance of installation of sub woofers, tips and warning for doing this job.

Depth and powerful sound are important for good quality of music. Speakers can be installed at various places inside the car like door panels, dash and rear decks. They enhance the sound effect for higher notes. But to enjoy lower tones adding a sub woofer to a factory stereo is the best choice. Let us see how to do that now.

First we look into list of things needed to complete this work. They are trim panel removal tool, speaker wires and Philips head screw driver. First we should remove the connection of ground cable with the battery of the car. Usually the negative lead of car battery connects the car frame. To do this we shall take the help of Philip head screw driver which loosens the clamp of the cable connected to the negative lead of the battery.

The next step is to search for the amplifier in the vehicle. In most cases it is factory made. The manual which is issued along with the vehicle by the manufacturer is to be referred often. The sub woofer is placed either in the car area in the rear end in the case of hatch backs or SUV or in the trunk of the car. The speaker wires are then connected to the corresponding outputs that is positive and negative ends of the amplifier.

Fourth step is very important. The speaker wires should be connected with the positive and negative terminals of the amps correctly. The next step needs some attention. The wires of the speaker should be routed to the place where sub woofers are present. Suppose if the location of sub woofers is not near the amplifier then wires can be taken under the carpet of the vehicle. Use trim panel removal tool for prying of panels at the openings of the door. The trim panels can be replaced by hand itself after laying the wires under the carpet.

The carpets are lifted and the wires are routed through this. Hiding the wires gives a custom look and avoids clumsy look. The trim panels are replaced manually. To fit them properly, pressure must be applied uniformly through out the panel’s length.

The positive wires are then connected to the positive terminal and in the same way the negative terminals connected with the negative wires. That is in general corresponding connections between sub woofer input and the speaker wires are made. At last a re connection is established between the vehicle battery’s negative lead post and the grounding cable. Then the cable clamps are fixed in its position and re installed using a Philips screw driver.

This article would have provided a complete answer on How to Install a Sub woofer in a Factory Stereo with step by step instructions without the help of professionals to do the job.

Want to find out more about Car Hifi, then visit Author Name’s site on how to choose the best Car Audio for your needs.