In this article we will discuss how to get good sound and power from stereo of car. For enhancing the lower tones of sound and adding bass ,installation of sub woofers is the best choice. This eliminates the need for purchasing an after market stereo. Let us learn How to Install a Sub woofer in a Factory Stereo.

Before we look at the steps for doing the job we should understand why speakers would not be sufficient to power the music. It is because speakers can improve the effect of sound of having only higher tones. The intricacies of lower notes , tones and bass can be taken care only with sub woofer.

This installation can be completed in five steps after which we shall discuss some useful tips. We should be ready with the following things for installation of sub woofers. They are amplifier, wire strippers , electrical tape. Amplifier kit , line out converter , sub woofers and box.

The stereo is then removed out of the dash. This is different for each vehicle and can be done using a manual of the car. After the stereo is removed, the wiring of the stereo is disconnected. The wiring can be either single or many attached together. The stereo is then connected to the harness adapter from the vehicle. The harness has markings that show how the connections have to be made.

Then, the cable for the signal and the lead for turn-on are connected to the harness adapter. The lead for turn-on is present in any wiring kit. These two cables are then touted to the vehicle’s floor through the rear part of the stereo. The carpets can be lifted using some tools for removing it. The cables can then be passed through the floor carpeting to the battery. It is advisable to do in opposite directions in order to minimise the interference.

The line out converter is successfully installed . We now need to understand what is the function of this. This LOC eliminates the need for replacement of head unit of factory as it enables the connection of RCA cables with our amplifier. For safety purposes grounding should be done. So locate a bolt made of metal. Connection is made between ground wire of the amplifier and metal bolt.

There is one optional thing which can be done that is provide proper insulation by wrapping the connections fully with an electrical tape. This is for providing a safer working and handling environment. Before cutting the wire just leave some more extra wire to use it when a proper crimp is not done. The wire ends are to be handled properly or else the ends may cause holes or it may hurt your finger.

One should always know How to Install a Sub woofer in a Factory Stereo , as it is one of the most important tool.

Learn more about Auto. Stop by Author Name’s site where you can find out all about Car stereo and what it can do for you.